Close the receiver of the fan and screw back the light kit firmly into place.Make the changes to match the configuration of the remote.Find the receiver box and remove the cover to access the DIP switches.Stand on a firm ladder, unscrew the light kit by moving the shade anticlockwise.(It means which switches are reading ‘On’ and ‘Off’) Open the back compartment of the remote control, expel the battery and memorize the DIP Switches settings on it.First of all, turn off the power at the main switch and turn the fan switch to ‘Off’.How to reset the DIP switches in a Harbor Breeze fan To solve this issue, you will have to reset the DIP switches.Ħ. Check if the DIP switches are not receiving nor transmitting remote commands.Check all the wirings and connections to ensure they are firmly installed and aligned accordingly.You will have to open your power panel in order to reset the breaker. The power connection could be off because of a tripped circuit breaker.Is your Harbor Breeze ceiling fan stopped working suddenly? Here are the possible reasons for this issue: The wires connecting the light kit to the housing wiring could be loose, therefore, secure them firmly by using more wire nuts.Replace the wiring of the light kit to make it work again. Check if the bulbs have any burn marks that indicate a short in the wires.After changing the bulbs that may have burned out, fasten them firmly and turn on the power. Firstly, check if the bulbs need replacement.Harbor Breeze light kit not workingĪre your Harbor Breeze light kits not working? If the ceiling fan is working but the lights not, here are some recommendations to find the main cause of the malfunctioning: If the ceiling fan has a light kit, press the on and off light buttons to sync them too. Now, press the High, Medium and Low buttons in quick succession and in less than 20 seconds to sync it to the fan (ensure to check the manual on the correct sequence of buttons you should press).Put back the battery as well as the compartment and turn ‘On’ the switch breaker.Make a new configuration that matches the DIP switches of fan if needed They must be similar for the ceiling fan to work. ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |